Everbuild Cemstrip is a cement, concrete and mortar stain remover.

Price Includes VAT

Cemstrip Concrete & Mortar Remover

• Removes wet and cured cement & concrete
• Easy to use
• Works on walls, paths, patios, tools and cement mixers, etc
• Clean-up with water
• Environmentally friendly
• Makes up to 10 times the volume of the bottle when diluted
  

Available in a 1-litre spray, 1-litre bottle & 5-litre bottle.

Uses of Cemstrip

• Removes cement, mortar and concrete on most mineral surfaces such as paths, patios and walls.
• Cleaning tools, cement mixers and other building equipment.

Cemstrip will also remove salts and efflorescence from the surface of mineral substrates and is a very effective general cleaner for removing ingrained dirt, grease and stains from paths and patios.

Cemstrip is a highly concentrated formula that can be diluted by up to 10 times with water to suit a variety of applications. Unlike hydrochloric acid-based products, Cemstrip can be safely used on most metal surfaces such as tools, cement mixers and other building equipment. Cemstrip is Non-hazardous in storage, transport and usage. It is also fully biodegradable.

Everbuild Cemstrip Mixing Instructions

• 9 parts water to 1 part cemstrip – Cleaning general stains and ingrained dirt from paths, patios and horizontal surfaces.
• 2 parts water to 1 part cemstrip – Cleaning light mortar stains from paths, patios, walls or vertical surfaces.
• 1 part water to 1 part cemstrip – Cleaning heavy mortar stains from walls or vertical surfaces.
• Neat – Cleaning tools, cement mixers and other building equipment.

How to use the Everbuild Cemstrip

1. When cleaning paths, patios, cement stains etc. from surfaces always thoroughly wet surfaces prior to application.
2. Do not apply to a dry surface. Always test a small inconspicuous area prior to full application.
3. Moisten surfaces with water and apply cemstrip with a brush or low-pressure spray (avoiding mist formation) from the top of the area downwards.
4. Leave for 5-10 mins then scrub/wash off with a hose, brush or power washer until the surface is clean.
5. Never allow the product to dry on surfaces.
6. Where a second application is necessary, repeat the procedure above.
7. Cleaning tools/equipment with the cam strip using a spray or brush.
8. Leave for 15 mins to act (light stains) or up to 3 hours for heavy contamination.
9. Wash off the product with clean water. Use a scouring pad on any stubborn stains.
10. Use a hot power wash to assist removal of staining from mixing equipment.
11. After using the cemstrip spray the tools with Everbuild XT44 Maintenance Spray.

Everbuild Cemstrip Data Sheet

Everbuild Cemstrip Safety Sheet